top of page

RESOURCES

The information and links  are provided for the convenience of our visitors and in no way signifies an endorsement of, or an affiliation with the organizations found on this page.Please contact our office at (702) 869-5001 or send us an email at rowcustom1@yahoo.com with any questions you have about the companies or services listed on our website.

 

National Plaster Council 
National Plaster Council is where you can find a multitude of information regarding plaster, applicators and research on plaster material

 

 

LINKS:

BBB OF NEVADA

NEVADA STATE CONTRACTORS BOARD

POOL AND SPA LAWS/REGULATIONS:

 

The following are additional guidelines to be followed during the start-up period:

As plaster cures, especially during the first 30 days, it is important to remove plaster dust in a timely manner by brushing and to stabilize water chemistry in the pool. Since chemicals can have a significant impact upon the life of your plaster it is suggested that only persons trained in this introduce chemicals to the pool. A re-plastered pool must be brushed at least twice per day until there is no longer visible plaster dust churned up by the brushing. Inadequate brushing may result in the plaster dust becoming permanently affixed to the surface of the pool. Pebble pools require limited brushing.

 

Start the pool equipment once the pool has been filled. Run the filter 18 hours a day for at least a week subsequent to plaster. Make sure that there is main drain suction to filter the dust from suspension in the water. Monitor filter pressure as the filter may need cleaning during this period due to the accumulation of plaster dust.

 

Do not swim in the pool until there is no longer evidence of plaster dust in the water and chemicals have been balanced.

 

Do not use the pool sweep cleaner for at least 21 days subsequent to the application of plaster.

 

Do not turn on the heater for at least ten days and longer if the pool is not in chemical balance.

 

INFORMATION:  Ph Maintenance, filtration, brushing and water balancing are all essential to maintaining a smooth clean finish that will last for years. Plaster is, however, made from reframed materials applied under conditions beyond our control and is seldom blemish free. No two pools ever look the same. Air temperature, wind, moisture, and exposure to direct sunlight affect all phases of construction and therefore, the finished ‘look’ of your pool. You may notice anyone of the following conditions. These are not considered a deficiency in materials or workmanship: Surface checking and crazing-Cement shrinks as it cures. These do not leak, and are usually to ‘tight’ to require patching. More noticeable in colored plaster.

 

Discoloration:

Brownish-Usually organic from dust/dirt

Greyish-Usually calcium deposits. ALL POOLS have some calcium deposits. Keep to a minimum by adhering to 2, 3, and 4 above.

  • Dark spots or blotches on colored plaster-This is the original color of the plaster-Plaster without any calcium deposits on it.

  • Dark specks in colored plaster-Inherent in cement pigments.

  • Mottling-Blotchy, cloudy, or discolored wavy look-caused by the curing process of cement.

  • Plaster feels rough throughout the pool-Due to chemical imbalance or improper brushing.

 

 

POOL CHEMISTRY patch12.png
CPO NSPF thLNP87RO3.jpg
npc certified.png
NPS START UP th9X1AHW4W.jpg
bottom of page